Wilbur Curtis TL-ILGD - Manual (Page 4)

4
REGUlAR AND PREVENTIVE MAINTENANCE IS ESSENTIAl IN
KEEPING yOUR GRINDER lOOKING AND wORKING lIKE NEw.
– ClEANING
1. The stainless steel outside case of the grinder may be cleaned with stainless steel polish.
2. Clean the hopper with a damp cloth.
3. you can clean inside the grinder housing with a stiff bristled brush to get out all of the old coffee
grounds. Refer to section on adjusting the grinds to open the housing. While cleaning the grinder, do not
wet inside the grinder housing.
CARE &
MAINTENANCE
TROUblE-
ShOOTING
GUIDE
SyMPTOM: MOTOR DOES NOT RUN
SyMPTOM: MOTOR RUNS bUT NO COFFEE COMES OUT
POSSIblE CAUSE SOlUTION
4. Shear disk may have broken. Change the shear disk (see page 6 for directions).
5. Funnel to grind housing may Cut off power to machine. Empty the hopper of beans.
be jammed. Clean where the hopper funnels into the grind housing.
POSSIblE CAUSE SOlUTION
1. Circuit breaker may be tripped. Grinder has a circuit breaker behind machine. Push in reset
button. you should hear a “click”.
2. Electrical cord may not be Push plug into outlet.
making contact.
3. Electrical outlet may not with voltmeter, determine if there is power at outlet.
have power.
SyMPTOM: GROUND COFFEE TEXTURE IS TOO COARSE
OR OF POOR QUAlITy
POSSIblE CAUSE SOlUTION
6. grinding burrs may be worn. Readjust the grind (see page 6).
7. housing cover may not be on Pull off the cover and clean the mounting surfaces.
straight or not seating correctly. Reassemble the housing.
cauTIon: do
not use any
substance con-
taining chlorine.
These products
will promote cor-
rosion.
This appliance is designed for commercial use. any servicing other than cleaning and
maintenance should be performed by an authorized Wilbur curtis service center.