Wilbur Curtis TL-ILGD - Manual (Page 6)

6
PROGRAMMING THE IlGD & Tl-IlGD GRINDER
your grinder has been adjusted at the time of manufacture to provide satisfactory performance in most situ-
ations. In the event that you would like to vary the settings the grinder can be reprogrammed. Both grinders
are programmed identically.
1. Place a paper filter beneath the grinder spout to catch coffee as it is ground.
2. Turn off the unit at the front panel, ON/OFF button.
3. Press and hold one of the grind buttons.
4. Press and release the ON/OFF button. Continue holding the grind button.
5. In the red window, the grind time on the button pressed will
appear. Continue to hold and the time digits will start at 00
and increase. Release the button to set the new time. The
table (left)can be used as a guide to estimate the amount
of ground coffee you dispense with the chosen setting.
6. wait for the motor to completely stop (10 seconds). To set
and exit, press and release any other grind button.
7. Repeat the above steps to reset any other grind button.
PROGRAMMING
ThE GRINDER
Time settings
in this table are
only approximate.
amounts will vary
with grind texture and specific
coffee bean. Weigh your out-
put, then make adjustments as
necessary.
ROUGh-IN
DRAWINGS
IlGD / Tl-IlGD
2.00"
(5.1 cm)
14.50"
(37.0 cm)
.75 "
(7.0 cm)
13.50"
(34.2 cm)
29.38"
(74.5 cm)
10.00"
(25.4 cm)
TOP ViEW
1.3
1.5
1.8
2.0
2.5
3.0
3.7
4
5
6
7
8
10
12
15
20
25
30
35
40
45
4.5
6.2
7.6
8.8
10.0
11.8
13.5
Seconds Ounces Seconds Ounces