Canon PIXMA MP560 - Manual (Page 676)

Select the product you want to use.
Scanners that are registered to the system are displayed. Select the checkbox of the product you want to
use.
You can select up to three scanners.
Click Instructions to open this page.
Note
If the scanner you want to use is not displayed, check the following conditions and click OK to close
the dialog box, then reopen it and select the scanner.
- The MP Drivers are installed
- Network setup is completed after installing the MP Drivers
- Network communication between the product and computer is enabled
If the scanner is still not displayed, see "
Troubleshooting ."
You do not need to use this software when scanning via USB or from a computer. See " Uninstalling
the Canon IJ Network Tool/Canon IJ Network Scan Utility " to delete it. You can scan via USB or from
a computer even if it is not deleted.
Page top
Page 676 of 949 pages Canon IJ Network Scan Utility Menu and Setting Screen