Canon PIXMA MP560 - Manual (Page 903)

1. Detected Access Points
The signal strength from the access point, encryption type, name of access point, and the radio
channel can be confirmed.
Important
If you connect to a network that is not protected with security measures, there is a risk of
disclosing data such as your personal information to a third party.
Note
Signal strength is displayed as follows.
: Good
: Fair
: Poor
Type of encryption is displayed as follows.
Blank: No encryption
WEP: WEP is set
WPA: WPA is set
WPA2: WPA2 is set
2. Update
Click to update the list of access points when your target access point is not detected.
If the target access point is set to the stealth mode, click Cancel to return to the previous screen
and enter the access point's Service Set Identifier in SSID.
Note
Make sure that the access point is turned on.
3. Set
Click to set the access point's SSID in SSID on the Wireless LAN sheet.
Note
Depending on your settings, WEP Details dialog box, WPA Details dialog box, or WPA2
Details dialog box appears when you click the Set button. In the dialog box, configure the
details to use the same encryption settings set to the access point.
Access points that cannot be used by this machine (including those configured to use
different encryption methods) are displayed grayed out and cannot be configured.
WEP Details dialog box
Page 903 of 949 pages Changing the Settings in the Wireless LAN Sheet