Canon PIXMA MP560 - Manual (Page 783)

U150 Install an appropriate ink tank.
Routine Maintenance
An ink tank error has occurred. (The lamp on the ink tank
is off.)
Replace the ink tank.
Routine Maintenance
The following ink has run out.
Replace the ink tank.
U163 Ink has run out. (The lamp on the ink tank flashes.)
Replace the ink tank and close the Scanning Unit (Cover).
Routine Maintenance
Printing under the current condition may damage the
machine.
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level.
Press and hold the machine's
Stop button for at least 5
seconds, and then release it.
With this operation, releasing the function for detecting the
remaining ink level is memorized. Please be advised that
Canon shall not be liable for any malfunction or trouble
which may be caused by continuation of printing under the
ink out condition.
Note
If the function for detecting the remaining ink level is
disabled, the ink tank in gray is displayed on the LCD
when checking the current ink level.
Routine Maintenance
There are no photos in memory card./
No photo data in USB flash drive. There is no image data saved on the memory card or the
USB flash drive that can be read by this machine.
The machine may not recognize the file if the file name or
the folder path contains certain characters. Use only
alphanumeric characters.
Photo data edited or processed on a computer must be
printed from the computer.
Note
When a photo was processed on a computer is
selected, "?" is displayed on the LCD.
The ink absorber is almost full.
Press OK to continue printing.
Contact the service center.
The ink absorber is almost full.
Press the machine's
OK button to continue printing. Contact
the service center.
Printer error has occurred
Contact the service center.
The machine error has occurred.
Contact the service center.
Timeout error has occurred.
Press OK. Some errors occurred while copying and a certain time
passed.
Press the
OK button to dismiss the error, and try to copy
again.
The device may be incompatible.
Remove the device and check the
manual supplied with the connected
device.
Check the device connected to the Direct Print Port. Printing
photos directly is possible with a PictBridge compliant device
or the optional Bluetooth Unit BU-30, or a USB flash drive.
A communication time out occurs if an operation takes too
long or if it takes too much time to send data. This may
cancel printing. In such cases, disconnect and reconnect the
USB cable.
When printing from a PictBridge compliant device,
depending on the model or brand of your device, you may
have to select a PictBridge compliant print mode on the
device before connecting it to the machine. You may also
Page 783 of 949 pages An Error Message Is Displayed on the LCD