Panasonic SC-CH350 - Manual (Page 58)

Concerning the Display
Selecting the display
Press DISPLAY on the tuner section.
DISPLAY
The unit’s display can be stepped through the input mode display,
present time, tape counter.
This feature comes in handy during recording when making a note
of the tape counter or checking out the present time for recording a
radio program.
When the input select button marked “CD" is used
Input display
r Tl 1 n- t 1 1 DECK Z1
i_ ±1 1 U- 1- I
z:>
nWml
Present time display
I n-r J
I o- -I Li!i
-III"® i polby hr i
Tape counter display
r Tt n n n 1 OECH i 1
/_ ±t U U U _
1 DOL&V hlA 1
•When there is no tape in both decks, the tape counter will display
About the spectrum display
Press DISPLAY momentarily on the amplifier sec­
tion.
-SPECTRUM
-MODE
^ DISPLAY~^
•The spectrum analyzer shows the level of each sound range with
five types of display described below.
•The spectrum analyzer display overlapped with the equalization
curve will change as follows.
[T1 Bar-type display
This display indicates the strength of the sound in each tonal range.
HEAVY Ct£AA soft HP. ST CAR ST
2j Peak-hold display
The peak sound value of each sound range is held on the display for
about one second after occurs.
EOFIAT HEAVY CLEAfl SOFT HP ST CARET
dB
in Aurora display
The peak sound value of each sound range is displayed in inverted
form.
EQflAT HEAVY CLEW SOFT H P ST CAR ST
...... Illllllllin
-va
dB
n Symmetry display
This display indicates the strength of the sound from up and down.
n Bass-mode display
This display appears only when you select the V. BASS mode.
(See page 49.) It shows the strength of the augmented bass level.
HUVY CtEVi SOFT H P ST CAfTST
dB
Note:
When you press V. BASS to ON in any display modes, the bar-type
display will be switched to appear.
■ To display the spectrum analysis display with­
out the equalization curve
Press and hold DISPLAY on the amplifier section.
-SPECTRUM
-MODE
V DISPLAY^
The equalization curve will no longer appear.
HEAVY OEAH SOFT h PST CARST
_ = = _' .Dtuiw
To resume the previous mode, press and hold DISPLAY once
again.