Panasonic SC-CH350 - Manual (Page 9)

2 Connect the LW/MW loop antenna.
1. Attach the antenna holder with screws (included) to the rear
panel.
2. Clamp the antenna to the antenna holder and connect the
antenna terminal to the rear panel.
3. Position the loop for the best reception.
You may attach the LW/MW antenna holder to a rack or other
structure.
Notes:
•To minimize noise pickup, keep the LW/MW loop antenna
away from the speaker cable, power cord, and metal sur­
faces.
•For better reception, keep the LW/MW loop antenna cord
along the heat prevention cover.
• Be sure to connect the cable from the right speaker to the
right terminal and the cable from the left speaker to the left
terminal.
• Be sure to connect only positive (red) wires to positive (- 1 -)
terminals and negative (black) wires to negative (-) termi­
nals.
Connection of speaker cables
1. Strip off the outer
covering, and twist the
center conductor.
Make sure the bare ends of the wires are not unraveled.
(If they are, twist them tight again.)
2. Insert the wire to the rear
panel and close the lever.
Notes:
•To prevent damage to circuitry,
never short-circuit positive (+)
and negative (-) speaker wires.
FOR UNITED KINGDOM ONLY
BE SURE TO READ THE CAUTION FOR
AC POWER SUPPLY CORD ON PAGE 3
BEFORE PROCEEDING TO THE STEP 4
Connect the AC power supply cord after you
have connected all other cables and cords.
For areas except Europe, Australia, New Zealand
If the power plug will not fit your socket, use the power
plug adaptor (included).
For areas except Australia and New Zealand:
Insertion of Connector
Even when the connector is per­
fectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as
shown in the drawing.
However there is no problem
using the unit.
Connector
Approx, 6 mm
Appliance inlet