Yamaha YSP-1100 - Manual (Page 67)

MANUAL SETUP
Select ANGLE TO WALL OR CORNER if this unit is
installed in the comer in your listening room. Adjust
the width and length of your listening room as well as
the distance of the listening position from this unit.
Listening position
from the unit
Choices for the room width and length:
2.0 m to 12.0 m
Choices for the listening position from this unit:
1.8 m to 9.0 m
Room width and length
fi)SEIII[|] PfiffiiflEES 7 .'7
Listening position from
the unit C 2.5r.'i ]
C a ]/C t ] : Up/Down [n>l]/Ct-]: Sel
CENTER]:Return
INSTALLED HEIGHT (Installed height of this unit)
Use to adjust the installed height of this unit.
Control range: 0.0 m to 3.0 m
Initial setting: 1.0 m
Fioor 0.0 m to 3.0 m
■ BEAM ADJUSTMENT (Beam adjustment)
Use to manually adjust the various beam settings. We
recommend that you select 5 beam as the beam mode
before adjusting these parameters.
Notes
• When INSTALLED POSITION is adjusted in MANUAL
SETUP (see page 62), the factory default value is automatically
set for this parameter except CENTER in FOCAL LENGTH
(see page 65).
• Depending on the beam mode settings (see pages 42 and 47),
some channel positions may not be available for selection. In
this case, “—” is displayed. When using the stereo plus 3 beam
as the beam mode, set the surround left and right signals to be
output from the front left and right channels.
Hots
When you set the INSTALLED POSITION parameter in
MANUAL SETUP (see page 62), the parameters newly set for
the width and length of your listening room are automatically set
as the factory default value.
mm fl[)jysitfni
a) H0RIZ0HTflL ANGLE
b) UERTICflL ANGLE
c>BEAM TRAUEL LENGTH
d>FOCAL LENGTH
e)TREBLE GAIN
[J l ]/[ t ] : Up/Dowri
CENTER];Enter
63
En