Input mode (input mode), Input trim (input trim), Last – Yamaha YSP-1100 User Manual
Page 73
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MANUAL SETUP
Select COMPONENT (1) to assign components to the
STB COMPONENT VIDEO IN jacks of this unit.
Choices:
TV,
VCR
Select COMPONENT (2) to assign components to the
DVD/AUX COMPONENT VIDEO IN jacks of this
unit.
Choices:
DVD,
AUX
COMPONENT
+ < 1 >... TO
(
2
)--- -■ DOD
( DOD
>
[A] / C
t
] : lJp--Doi..in [-<4 ] / [H: Se 1
[ENTER]:Return
Select COMPOSITE (3) to assign components to the
DVD/AUX VIDEO IN jack of this unit.
Choices:
AUX,
DVD
COMPOSITE
;)...... flux
( RUN
[
a
]/[
t
]:Ijp/Down H]/[N-]:Sel
[ENTER]:Return
■ INPUT MODE (Input mode)
Use to designate the input mode for the input sources
connected to the DIGITAL INPUT jacks when you turn on
the power of this unit. For information on the types of
audio signals that can be output by this unit, see “Surround
modes and recommended sources” on page 44.
Choices:
AUTO,
LAST
[-i|]/[^]: Select
[ENTER]:Return
Select AUTO to allow this unit to automatically detect
the type of input signal and select the appropriate input
mode.
Select LAST to set this unit to automatically select the
last input mode used for that input source. If the type of
input signal is different from the setting, no sounds will
be produced.
■ INPUT TRIM (Input trim)
Use to adjust the input level of the input source.
C)l
UCR
RUN
DUD
RNRLOG-■
OPTICRL-
RNRL0G--
CORNIRL-
CORNIRL-
-3.0dB
-3.0dE
-3.0dB
-3.0dB
-3.0dB
Select TV ANALOG to adjust the level of audio and
video signals input at the TV/STB analog audio input
jacks of this unit.
Control range: -6.0 dB to 0.0 dB
Initial setting: -3.0 dB
Select TV OPTICAL to adjust the level of audio and
video signals input at the TV OPTICAL IN jack of this
unit.
Control range: -6.0 dB to 0.0 dB
Initial setting: -3.0 dB
Select VCR ANALOG to adjust the level of audio and
video signals input at the VCR analog audio input
jacks of this unit.
Control range: -6.0 dB to 0.0 dB
Initial setting: -3.0 dB
Select AUX OPTICAL to adjust the level of audio and
video signals input at the AUX OPTICAL IN jack of
this unit.
Control range: -6.0 dB to 0.0 dB
Initial setting: -3.0 dB
Select DVD COAXIAL to adjust the level of audio and
video signals input at the COAXIAL IN jack of this
unit.
Control range: -6.0 dB to 0.0 dB
Initial setting: -3.0 dB
69
En