Setting the factory preset, Demos off, Lu^ un – Yamaha YSP-1100 User Manual
Page 83
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING SYSTEM PARAMETERS
Press
<1
/
1>
to switch between DEMO: ON
and DEMO: OFF.
lU^ UN
Setting the FACTORY PRESET
You can reset all of the parameters of this unit to the
factory presets. This procedure completely resets ALL the
parameters in SET MENU.
NotB
After performing the following procedure you must run the
AUTO SETUP again to match your surround sound environment.
1
Repeat steps 1 to 3 in “Using the system
parameters” on page 76.
2
Set the operation mode seiector to YSP to
switch to the operation mode of this unit.
TV/AV
iiiii
DEMOS OFF
• Select DEMO: ON to activate the demo mode.
• Select DEMO: OFF to deactivate the demo mode.
5
Press STANDBY/ON on the front panei to set
this unit to the standby mode.
The new setting will be activated when you turn on
the power of this unit next time.
Press ENTER to test the sound beam.
The sound beam being output shuttles between left
and right. Press ENTER again to stop shuttling.
Press ^ on the remote control so that
FACTORY PRESET is shown in the front
panel display.
F
h
CT
u
RV
preset
=
4
Press ENTER.
79
En