Setting the turn on volume, Setting the demo mode, Setting the turn on volume setting the demo mode – Yamaha YSP-1100 User Manual

Page 82: Urh oh oolufle, Demo mode

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ADJUSTING SYSTEM PARAMETERS

Setting the TURN ON VOLUME

You can set the initial volume level when the power of this
unit is turned on.

1

Repeat steps 1 to 3 in “Using the system

parameters” on page 76.

2

Set the operation mode selector to YSP to

switch to the operation mode of this unit.

TV/AV

vsF

n

Press STANDBY/ON on the front panel to set

this unit to the standby mode.

The new setting for the maximum volume level will
be activated when you turn on the power of this unit
next time.

Setting the DEMO MODE

You can test the beam output from this unit to experience
the sound beam.

Press

on the remote control so that

TURN ON VOLUME is shown in the front

panel display.

'URH OH OOLUflE

=

4

Press ENTER.

You can also perform this function simply by pressing INPUT on
the front panel. A sound beam is output from this unit when you
press and hold INPUT for more than 2 seconds. The sound beam
shuttles between left and right twice, and then stops.

1

Repeat steps 1 to 3 in “Using the system

parameters” on page 76.

2

Set the operation mode selector to YSP to

switch to the operation mode of this unit.

yvml

i\l

Press ^ ^ on the remote control so that

DEMO MODE is shown in the front panel

display.

5

Press <| / D to adjust the initial volume level.

Control range: MAX, 99 to 01, OFF
Control step: 1

DEMO MODE

76

En

Advertising