Panasonic PV-D4752 - Manual (Page 30)

таре uperaiion
Search System , .
For each recording, an invisible index mark is placed «"»¡e tape, A
information are also included for timer recordings. These marks are used to access or
scan recordings.
Index Search
1
INDEX SEARCH
ENTER INDEX NUMBER :1
USING 1-9 KEYS
FORWARD SEARCH :FF
REVERSE SEARCH'.REW
NEXT iSEARCH
EXIT '.STOP
Press SEARCH*
to display SEARCH
in Stop or Play
mode, and then
press NUMBER
keys
to select recording
number.
• To calculate
number, see below.
Press FF/SLOW+
or REW/SLOW- on
the remote to start
search.
INDEX SEARCH
FORWARD SEARCH : FF
REVERSE SEARCH : REW
To cancel,
press
PLAY
or
STOP.
I]
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
I]
Program End Search
Locates end point of recording for continuity.
1
Play begins at
search end.
To search forward
or back 1 index,
press FF/SLOW+ or
REW/SLOW- on the
remote while
screen left is
displayed (10 sec.).
■ To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
• If Index Search is started very close to an
index mark, that index mark may not be
counted in the search.
Press SEARCH twice
to display SEARCH in Stop or Play
mode.
PROGRAM END SEARCH
SEARCH START: FF
EXIT :SEABCH
Press FF/SLOW+
on the remote to
start PROGRAM
END SEARCH.
To cancel,
press
PLAY
or
STOP.
Examples of Program End Search.
Fia.1
\\ f Program 1 ) 11 Program 2 or BLANK 11
the current tape position
Press SEARCH button ^ End Point
Fla. 2
the current tape position
Press SEARCH button
^End P
4
End Point
1 i
BLANK
III
Program 2
jj
1 t If search exceeds
a few seconds in
BLANK area.
Upon locating end point,
search continues 7 sec. past end point,
-► tape rewinds to 10 sec. before end point,
tape plays to end point and stops.
NOTE: \ indicates start points of each recording.
If Program End Search is started very close to
an index mark, that mark may be skipped over.
30
For assistance, please call ■. 1 -S 00 - 211 -PANA( 7262 ) or send e-mail to: [email protected]