Panasonic PV-D4752 - Manual (Page 35)

copying Your Tapes (Dubbing)
Connection
D VD /V CRD EC K TV Front of DECK
VIDEO IN 2 L-AUDIO 1N2-R
o o o
(AudioA/ideo In Terminals
on the front of DECK are
available)
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on DECK.
To monitor the dubbing, also connect TV as shown.
Connect “L” and “R” AUDIO OUT terminals on Playing VCR to “L” and “R”
^ AUDIO IN terminals on DECK.
In place of Playing VCR, you can use other equipment, such as a Camcorder.
Simply connect the unit’s Audio/Video outputs to DECK.
1
Playing (Source) VCR
Insert a pre-recorded tape.
Recording (Editing) DECK
Insert a blank tape with record tab.
Press INPUT to set DECK Input mode to
LINE for Video Input.
(See “Selecting the Input Mode” below.)
Press PLAY, then PAUSE/STILL Press REC, then PAUSE/STILL
immediately to enter PLAY/PAUSE immediately to enter REC/PAUSE
mode.
mode.
______ The operation of steps 4 and 5 must be done on both ________________
playing and recording VCRs at the same time.
Press PLAY to start dubbing.
Playing VCR starts playback. Press PAUSE/STILL to start dubbing.
DECK starts recording.
Press STOP to stop dubbing. Press STOP to stop dubbing.
To Monitor Dubbing on TV
1 Turn TV on and tune to the Recording
VCR channel (CH 3 or CH 4).
2 Set the VCRATV Selector on DECK to
“VCR.”
Dubbing tapes protected with Copy
Guard will have poor quality results.
I Selecting the Input Mode
Method 1 : Press INPUT repeatedly.
Channel Number*-* LINE1 ■<-* LINE2
Method 2: Press CH A/T.
Display will change as below.
---
Press t ( (CABLE) (TV) 1 Press A
Vk^LINE2<-*-LINE1*-*-125 or
• “LI” or “L2” lights up on Multi Function Display
(about 4 seconds) when LINEI or LINE2 is selected.
• LINEI : For rear audio/video connection.
LINE2: For front audio/video connection.
Caution:» Unauthorized exchanging and/or copying of copyrighted recordings may be
copyright infringement.
• Please note that some tapes cannot be dubbed on DECK. Also, it is not
possible to dub DVD/ Video CD/ CD to VHS tapes using DECK.
35