STIEBEL ELTRON Accelera 300 E - Manual (Page 18)

18 | Accelera® 220-300 E www.stiebel-eltron-usa.com
INSTALLATION
Preparations
9.4 Siting the appliance
  Carefully undo the cardboard packaging at the clips.
D00000
34
79
7
1
1 Cardboard packaging clips
The appliance is secured to the pallet with metal brackets and
screws. The metal brackets are hooked on to the feet underneath
the fl oor plate of the appliance.
1. 2.
D00000
34
79
8
1
1 Metal bracket fi xing bolt
  Remove the fi xing bolts of the metal brackets from the pallet.
  Push the metal brackets a little towards the tank center, to
unhook them from the appliance feet.
  Pull the metal brackets out from underneath the appliance.
!
Material losses
Take note of the appliance's weight and top-heaviness.
  Slightly tip the appliance and carefully roll the appliance off
the pallet.
  Bring the appliance in its fi nal location.
9.5 Minimum clearances
14˝
(0.4 m)
2´ (0.6 m)
8˝ (0.2 m)
6´ (1.8 m)
Air flow
intake
Air flow
intake
Air flow
exhaust
Air flow
exhaust
2´ (0.6 m)
Air flow
intake
Air flow
exhaust
6´ (1.8 m)
Minimum room volume:
800 ft
2 , 10´ x 10´ x 8´
(22.7 m 2 , 3 m x 3 m x 2.4 m)
Acceptable positioning, vent parallel to a wall:
Acceptable positioning, vent parallel to a wall in a corner:
An object
next to the
unit must
be less than
42˝ high
2´
(0.6 m)
2´
(0.6 m)
8˝ (0.2 m)
8˝
(0.2 m)
6´
(1.8 m)
≤42˝
(1.1 m)
  Maintain the minimum clearances.
!
Material losses
The top of the appliance should be made horizontal.
  Level the appliance horizontally using the height-ad-
justable feet.
D00000
34
8
0
6