360 Systems MAXX2400HD - Manual (Page 47)

Page 46 MAXX-2400HD Owner’s Manual
Playing a Clip from the GUI
Video Playback can be done on all four channels, individually or simultaneously. The record-
capable channels (1 and 2) can record or play, but not both at once. Follow these steps to play a clip:
Beginning Playback
1. Select FILE>OPEN from the Transport Window of Channel 1, 2, 3 or 4. The Clip Navigator
shown in Figure 14 appears.
2. Navigate the folder structure if necessary by clicking on the folders.
3. Select the clip to be play by double-clicking it.
4. When the Transport Window indicates Idle Ready, the clip can be played by clicking PLAY.
Figure 14 – Channel-1 Clip Navigator in “Open” Mode
Looping a Clip
Clicking on the LOOP checkbox in the Transport View will cause a clip to loop until LOOP is
unchecked, or until STOP is clicked. LOOP may be checked or unchecked before or during
playback, but must be changed at least 2 seconds before the end of clip to take immediate effect.
Pausing a Clip
Click PAUSE at any time to pause a clip. Click again to resume. The PAUSE button is the same
key as the PLAY button.