360 Systems MAXX2400HD - Manual (Page 53)

Page 52 MAXX-2400HD Owner’s Manual
Programming GPIO Outputs
The MAXX-2400HD has twelve General Purpose Outputs, referred to as GPO 1 through 12. Each
can be programmed to go active on the selected channel when one of the following events occurs:
IDLE Transport returns to idle
PAUSED Transport is paused
STOPPED Transport is stopped
PLAYING Transport is playing
RECORDING Transport is recording
RAID System Fault RAID or System Fault
NO GENLOCK No genlock
NO VIDEO INPUT No video at the selected input
PLAYLIST Control GPO via playlist
To program a GPO output, select EDIT->CONFIGURE->GPO. The screen of Figure 16 is
displayed. GPO 1 through 12 are triggerable outputs. The checkboxes to the right of each selection
represent channel 1, 2, 3 and 4. GPO 9 is shown with the trigger option pulldown expanded.
1. To activate one of the GPO, pulldown the event menu and select which event will activate
the GPO.
2. Select an associated channel where applicable by checking the channel checkbox.
3. Click APPLY to activate.
Figure 16 - GPO Configuration Screen