360 Systems MAXX-2400SD - Manual (Page 22)

____________________________________________________________________________________
Page 22 MAXX 2400 Owners Manual
CONTROL MODULE ( CXP ) CONNECTIONS
The CXP Module is an external 1RU rack-mountable module that provides for the connection of
the serial ports for automation control and the GPIO interface. Use the supplied 68 Pin cable.
Connect one end to the connector on the rear of the CXP Module. Connect the other end to the
CXP Expander port on the rear of the unit. Note that there are two cables supplied for initial
connection. Both are identical and may be used to connect either module.
CAUTION!!
It is possible to plug the CXP1 Module into the AXP1 Module Connection. Damage to the system
may occur if power is applied with the CXP1 plugged into the AXP1 connector. The CXP1
connector on the MAXX 2400 is clearly marked. Connect the CXP1 module per Figure 5. Be
certain it is properly connected before applying power to the system.
Figure 5 - CXP1 Connection to main chassis