360 Systems MAXX-2400SD - Manual (Page 24)

____________________________________________________________________________________
Page 24 MAXX 2400 Owners Manual
BASIC OPERATION
POWER ON/OFF
Connecting the dual power supplies
Maxx 2400 is equipped with fully redundant power supplies. Connect each power supply to a
separate source of AC power. Looking at the rear of the unit, the two IEC main power receptacles
are located on the left. The unit will operate indefinitely on a single supply. If AC power is lost on
one of the two supplies, a high-pitched alarm will sound to indicate the power loss. The MAXX
2400 will accept world-wide power sources in the range of 100-240 volts AC, 50-60 Hz. The
server is shipped with a power cord appropriate for the region in which it is sold. Replace the
power cord only with one of the same type and rating.
Power On
The blue front panel button initiates start-up and shut-down of the MAXX 2400. Press it
momentarily to start the server. A sequence of start-up screens will appear, ending with the
display of the 4-channel Graphic User Interface ( GUI ) ( Figure 7 on Page 25 ).
During the first power on the system must be connected to a keyboard, monitor and mouse. The
Image Server will ask you to accept the Software Licensing Agreement before it will operate. This
screen will only appear during the initial startup.
Power Off
When the MAXX 2400 is running, pressing the blue front panel button momentarily will cause the
system to begin an orderly shutdown. In the event that the system has stopped responding to
commands and will not shutdown, hold the button in for 4 seconds to force a power down.
CAUTION:
USE THE FOUR SECOND SHUTDOWN ONLY IF THE SYSTEM IS NOT RESPONDING.
LOSS OF DATA CAN OCCUR WHEN THE OVERRIDE SHUTDOWN IS USED.
CAUTION:
A LWAYS DISCONNECT BOTH POWER CABLES ANY TIME THE TOP PANEL IS TO BE REMOVED .
Serious damage to the server can occur if service is attempted with AC power attached.
The front panel power switch does not disconnect AC power!