360 Systems MAXX-2400SD - Manual (Page 44)

____________________________________________________________________________________
Page 44 MAXX 2400 Owners Manual
Programming GPIO Inputs
The MAXX 2400 has six General Purpose Inputs, referred to as GPI 1 through GPI 6. Each GPI can
be programmed to trigger one of the following events on a channel.
CUE Cue a clip
JUMP Cue selected clip for immediate playback (Playlist Mode only)
NEXT Prepare next clip in a playlist for playback (Playlist Mode only)
PAUSE Pause a clip
PLAY Play a clip
RECORD Start a recording
SELPREV In Playlist Mode – Navigate to clip above currently selected clip
SELNEXT In Playlist Mode – Navigate to clip below currently selected clip
STOP Stop a clip
To program a GPIO Input, select EDIT->CONFIGURE->GPI. The screen of Figure 17 is
displayed. GPI 1 through 6 are the six programmable inputs. The checkboxes to the right of each
selection represent channel 1, 2, 3 and 4. GPI 5 is shown with the trigger option pulldown
expanded.
To activate one of the GPI, check the checkbox for the channels of interest, then pulldown the
event menu and select which event will be triggered when the GPI goes active. Click APPLY to
activate.
Figure 17 - GPI Configuration Screen