Cisco IAD2430 - Manual (Page 63)

3-27
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
OL-4234-06
Chapter 3 Installing Cisco IAD2430 Series IADs
Connecting Cables
Figure 3-24 Tightening the Captive Screws
Step 4 Pull the Velcro strap up until tight, then down and affix the strap to other Velcro side (see Figure 3-25 ).
Figure 3-25 Tightening the Velcro Strap
Connecting a Serial Interface Port to a CSU/DSU or a Synchronous Modem
Use the procedure in this section to connect the serial interface port to a CSU/DSU or to a synchronous
modem.
The serial port (S0) can operate as follows:
• DTE or DCE with the following signaling:
– EIA/TIA-232
– EIA-TIA-449
– V.35
281202
IAD2435-8FXS
FastEtherne
t
WAN
0/1
0/0
T1/E1
FXS
281203
IAD2435-8FXS
FastEthernet
WAN
0/1
0/0
T1/E1
FXS