Cisco OL-21636-01 - Manual (Page 182)

8-16
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 8 Managing an L2VPN Service Request
Creating an L2VPN Service Request
Step 17 When you are finished editing the end-to-end wires, click Save.
The service request is created and saved into ISC.
Creating an EWS (EPL) L2VPN Service Request without a CE
This section includes detailed steps for creating an L2VPN service request without a CE present for EWS
(EPL). If you are creating an L2VPN service request for an ERS (EVPL), ATM, or Frame Relay policy,
see
Creating an ERS (EVPL), ATM, or Frame Relay L2VPN Service Request without a CE, page 8-11 .
Step 1 Create the L2VPN service request for EWS (EPL) without a CE.
The L2VPN Service Request Editor window appears. (See Figure 8-22 .)
Figure 8-22 EWS (EPL) Service Request Editor
Step 2 Click Select VPN to choose a VPN for use with this PE.
The Select a VPN window appears with the VPNs defined in the system.
Step 3 Choose a VPN Name in the Select column.
Step 4 Click Select.
The End-To-End Wire Editor window appears with the VPN name displayed. (See Figure 8-23 .)