Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 26)

HI-3000 Series 12
Operation and Installation
FIG. 22: DRY CONTACT WIRING DIAGRAM
Step 3. Go to the product service manuals (Chapter 6) for
instructions on how to map to the digital inputs.
Output Relay Wiring
The HI 3000 Series has 4, OPTO22 solid state relays. Please
see Relays in Chapter 2 - Specifications of each product Ser-
vice manual for details.
Step 1. Wire into the output relay of your choice.
Step 2. Go to the product service manuals (Chapter 6) for
instructions on how to map to the output relays.
Load Point Connections
FIG. 23: REAR PANEL/LOAD POINT CONNEC-
TIONS
C2
®
Load Point Connection
WARNING: L OAD CELL CABLE LENGTH HAS BEEN CAL -
CULATED INTO C2 CALIBRATION DATA . H ARDY P ROCESS
S OLUTIONS RECOMMENDS THAT YOU DO NOT CUT YOUR
A DVANTAGE OR A DVANTAGE L ITE LOAD SENSOR CABLE ,
AS YOUR C2 ACCURACY WILL BE AFFECTED AND THE
WARRANTY WILL BE VOIDED .
Cable color Code for C2 Load Points (left to right facing the
rear panel):
• Shield Ground Wire
• C2- Violet
• C2+ Grey
• EXC- Black
• SEN- Brown
• SIG- White
• SIG+ Green
• SEN+ BLUE
• EXC+ RED
Step 1. Remove the factory installed jumper from the ter-
minal block if you are connecting an 8 wire cable
from the junction box.
Step 2. Connect the cable (Recommended load cell cable:
Hardy Instruments Prt. # 6020-0001) wires to the
Channel 1 terminal block according to the cable
color chart.
NOTE: To purchase Hardy Load Cell cable, contact your
local Hardy Representative or Distributor.
Step 3. Plug the terminal block into the Channel connector
on the rear panel.
Step 4. For more information concerning C2 Load Point
connections, consult the individual HI 3000 Series
Product, Installation and Service Manual.
Non-C2 Load Cell Connection
Cable color Code using Hardy cable from a junction to an
instrument - for Non-C2 load cells:
• Shield Ground Wire
• C2- Not Used
• C2+ Not Used
• EXC- Black
• SEN- Brown
• SIG- White
• SIG+ Green
• SEN+ Blue
• EXC+ Red
Step 1. Remove the factory installed jumper from the ter-
minal block if you have 6 wire load cell cable that
includes sense wires from the load cell or junction
box.
Step 2. Connect the cable (Recommended load cell cable:
Hardy Prt. # 6020-0001) wires to the J9 terminal
block according to the Non-C2 cable color chart.
Step 3. Plug the terminal block into the Channel 1 (J9) con-
nector on the rear panel.
Step 4. For more information concerning Non-C2 Load
Point connections, consult the HI 3000 Series
Installation and Service Manual.
RS 232 Connection
The RS 232 Connection provides for a serial port for trans-
mission to a Printer or a Scoreboard. To configure the Printer
or Scoreboard see Chapter 4/Serial Port Parameters in the HI
3030 Service Manual.
Gnd 1 2 3 4 5