Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 32)

HI-3000 Series 18
Operation and Installation
FIG. 46: DEVICENET/SELECTING NODE ADDRESS
Step 11. When you have selected the correct node number
for the HI 3000 instrument, press the Enter button.
Step 12. Press the Exit button until you are back to the
standby display.
ControlNet Option Card Installation
CAUTION: M AKE SURE THAT YOU USE AN ANTI - STATIC
STRAP WHEN INSTALLING THE C ONTROL N ET O PTION
C ARD .
Step 1. Position the ControlNet Option Card with the back
plane connector facing Option Slot #0. (See Fig.
47)
NOTE: You can only use Option Slot #0 when installing
the ControlNet card.
FIG. 47: CONTROLNET/OPTION CARD
Step 2. Slide the ControlNet Option Card into Slot #0. (See
Fig. 48)
FIG. 48: CONTROLNET/SLIDE INTO OPTION SLOT
#0
Step 3. Push the ControlNet card up against the back plane
and gently press until the card connector seats in the
back plane connector.
Step 4. Use a phillips head screw driver and install the two
(2) screws that fasten the ControlNet card panel to
the HI 3000 Instrument Chassis. (See Fig. 49)
Step 5. Tighten the screws until the ControlNet panel is
snug. Do not overtighten.
Step 6. Connect the BNC ControlNet cables to the BNC
connectors on the ControlNet Option Card.
NOTE: When installing the ControlNet Option Card with
the HI 3000-RC (NEMA 4X rear cover) you must
use a 90° elbow connector on the ControlNet
cable to clear the rear cover.
Option Slot 1
Option Slot 0