KEYENCE KV Series - Manual (Page 19)

17
INSTALLATION PROCEDURE
This section describes how to attach a connected unit directly to a panel, to
a DIN rail, or to a DIN rail with an expansion unit spacer.
■ Attaching a unit directly to a panel
Attach a metal fixture for screw tightening to a KV Series basic unit with set
screws. Then, attach the basic unit with a metal fixture directly to the panel.
■ Attaching a unit to a DIN rail
Hang an upper claw of a KV Series basic unit to the upper side of the DIN
rail, and press the basic unit onto the DIN rain until you hear a click.
■ Removing a unit from a DIN rail
Pull a lower claw of a KV Series basic unit downward from the front direction
using a screwdriver, and then remove the basic unit from the DIN rail.
Attaching an expansion unit spacer
When an expansion unit spacer is attached to a KV Series expansion unit, its
height becomes flush with an AC power type KV Series basic unit.