AERCO ProtoNode Gateway Rev 1 (with internal LEDs) - Manual (Page 33)

Page 33 of 64
USER MANUAL
AERCO/ProtoNode Gateway
OMM-0080_0D
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 • Phone: 800-526-0288 VD2:011712
1
GF-129
Appendix C. CONFIGURATION INFORMATION
C.1 Default Modbus RTU COM Settings for AERCO Controllers
Serial Port Setting ACS, BMS II, BMS ECS/SP
BCM
(Modulex)
C-More
Baud Rate ≤19200 ≤38.4 9600 9600
Data Bits 8 8 8 8
Stop Bits 1 1 1 1
Parity None None None None
Configuration Controllers
Modbus Default
Address
12
C-More
Controllers
&
1 ACS/BMS II/BMS
C-more 1 1
C-more 2 2
C-more 3 3
C-more 4 4
C-more 5 5
C-more 6 6
C-more 7 7
C-more 8 8
C-more 9 9
C-more 10 10
C-more 11 11
C-more 12 12
ACS /BMS II/BMS 128
4
Modulex
Controllers
&
1 ACS/BMS II
Modulex 1 1
Modulex 2 2
Modulex 3 3
Modulex 4 4
ACS /BMS II/BMS 128
4
ECS/SP
ECS 1 29
ECS 2 30
ECS 3 31
ECS 4 32
For Profiles defined in Section C.2.6, the ECS/SP Modbus default point addresses are defined below.
Configuration Controllers
Modbus Default
Address
6
ECS/SP
ECS 1 17
ECS 2 18
ECS 3 19
ECS 4 20
ECS 5 21
ECS 6 22