4G Systems XSBox R4v - Manual (Page 13)

XS BoxR4v
13
Instructions for use
General
■ XSBoxR4v is a device which is designed for use only in heated, dry and dust-free buildings. The device may not
be mounted or set up in a place which is exposed to direct sunlight or direct heat impact. The slits and vents serve
to ventilate the device. These vents should not be covered. The device should not come into contact with fire or
flames and may not be used in areas with a potentially explosive atmosphere.
■ The device must not come into contact with liquids, as this could lead to electric shocks, short-circuits or destruc-
tion of the device.
■ Do not open the housing of XSBoxR4v. Warranty claims become void on unauthorised opening of the housing
or improper repairs. In addition this could lead to damage for the user and for the device.
■ The device should not be installed during a thunder storm and should be disconnected from the electricity network.
LAN cabling
XSBoxR4v cabling can be extended without a problem. Cables in the appropriate length can be bought at computer trade
shops. However please note the following instructions.
■ Use a so-called Cross-Link network cable 10BT with STP (Shielded Twisted Pair = shielded), should you wish to
connect your computer directly to the XSBoxR4v without using a switch or hub.
■ Use a network cable 10BT, 1:1-wired and with STP (Shielded Twisted Pair = shielded), should you wish to operate
the XSBoxR4v on a switch or hub.
■ Maximal cable length is 100 m.