Canon XH A1 - Manual (Page 20)

20
Using the Wireless Controller
When you press the buttons on the wireless
controller, point it at the camcorder’s remote
sensor.
Inserting the Batteries
The wireless controller operates with two AA (R6)
batteries.
1. Open the battery cover.
2. Insert the batteries following the + and –
markings.
3. Close the battery cover.
 The camcorder and wireless controller are equipped with 2 remote sensor modes ( 102). If the
wireless controller does not work, verify that the camcorder and wireless controller are set to the
same mode.
 When the camcorder cannot be operated with the wireless controller, or when it can only be
operated at very close range, replace the batteries. Make sure to replace both batteries at the
same time.
 The wireless controller may not work properly when the remote sensor is located under strong light
sources or direct sunlight.