Installing the paper output receiver – Canon BJC-8500 User Manual
Page 47
42
Canon BJC-8500 User’s Manual
Installing the paper output receiver
The paper output receiver is installed above the paper cassette on the front
of the printer. The paper output receiver receives each printed sheet as it is
ejected from the printer and holds it for a few seconds before the movable
flaps gently let it down on top of the stack. This avoids staining between
stacked sheets by allowing the sheet below to dry for a few seconds before
the next sheet is stacked on top of it.
During a long print job, do not allow the printed sheets to stack high-
er than 15 mm (about 1/2 inch), approximately 50 sheets of Plain
Paper or 40 sheets of High Resolution Paper HR-101.
1
While holding the paper output receiver at a slight angle, insert it into
the slot
①
above the paper cassette and lower it
②
gently as you slide
it into the printer.
Flaps
Receiver paper guide
②
①