Loading paper in the sheet feeder – Canon BJC-8500 User Manual
Page 49
Loading paper in the sheet feeder
The following features apply to use of the sheet feeder:
■
The sheet feeder can hold a stack of paper for automatic feed.
■
The sheet feeder can be adjusted to the width of a variety of standard
sizes.
■
Thick paper (max. 0.25 mm) must be printed one sheet at a time with
manual feeding and fed from the manual feed slot on the back of the
printer. (
☞
81)
■
The media listed in the table below can be loaded in the sheet feeder. The
number of sheets in the stack varies with the type of media you are going
to load.
Media Type
Print Side Up
Limit
Page
Banner Paper
Either side
1
(
☞
74)
Bubble Jet Paper LC-301
Either side
100
(
☞
59)
Envelopes
No-flap side
15
(
☞
60)
Fabric Sheet FS-101
Cloth side
1
(
☞
78)
High Gloss Photo Film HG-201
Glossy Side
1
(
☞
73)
High Resolution Paper HR-101
Whiter side
80
(
☞
64)
Plain Paper (64~90 gsm)
Either side
100
(
☞
59)
Transparency CF-102
Either side
50
(
☞
71)
T-Shirt Transfer TR-201
Rough side
1
(
☞
77)
Glossy Photo Paper GP-301
Glossy side
20
(
☞
65)
Glossy Photo Cards FM-101
Glossy side
20
(
☞
68)
The media listed in the table above are available in a variety of standard
sizes. (☞ 56)
The procedure below describes how to load Plain Paper or Bubble Jet
Paper in the sheet feeder. For details about loading and handling other
media, refer to the referenced page numbers in the table above.
1
Slide the paper guide to a position slightly wide of the position mark
for the paper you want to load.
2
Check the envelope guides on both sides of the sheet feeder and make
sure they are both down and locked.
3
Pick up a stack of about 100 sheets and fan the stack to remove static
cling. Tap the front edge of the stack against a flat surface to make sure
the edges and corners of the stack are square.
44
Canon BJC-8500 User’s Manual