Kenwood KR-V990D - Manual (Page 13)

Onerations
I
Turn on the receiver.
Set the input selector to the component you
want to control.
I Use a component control selection key to
select the component you want to control.
I Refer to the "Remote control key operation
table" and press the key corresponding to the
operation you desire.
Operating distance
•When pressing keys in succession, press each key firmiy and be sure to wait at least 1 second before pressing the next key.
Remote control key operation table
'''^..Connponent control
^"^.^election keys
Key names
RECEIVER
CZI
TAPE A
1 1
TA^D
1_____ 1 TAPES)
CD
CZl
UD
(ZZI
(Systenn Control
operation)
TAPE B/MD
CZI
{For MD)
POWER
O POWER key (--------- )
REMOTE POWER key
■p II key II (Pause) II (Pause)
© ►/!! key BAND key »gQ ► (Play)
►/H
(Play/Pause)
► (Play)
O key ^ ^
P.CALL (A) key
{When the input is set to TUNER)
►► (Fast
forward)
»i (Skip)
© key
P.CALL (V) key
{When the input is set to TUNER)
◄◄ (Rewind)
(Skip)
o-key <d>
AUTO key
{When the input is set to TUNER)
■ (Stop)
REC
© REC key (g) • (Record) Disc Skip • (Record)
© ANY key (A)
ANY key (V) \/
TUNING (A) key
(When the input is set to TUNER)
► (Play) ►► (Search)
TUNING (V) key
(When the input is set to TUNER)
◄ (Play) (Search)
1. The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks.
2. Replace both batteries with new ones when you notice a shortening of the distance from which the remote control will operate.
3. Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to prevent malfunction.