Kenwood KR-V990D - Manual (Page 6)

rnrnrsimmim
Make connections as shown below.
The supplied loop antenna is for use indoors. Place it as far as
possible from the receiver, TV set, speaker cords and power
cord, and adjust the direction for best reception.
AM loop antenna
FM indoor antenna
If reception is poor with the loop antenna, extend a vinyl-
coated wire (more than 6 meters long) outdoors, without
disconnecting the loop antenna.
AM outdoor antenna
--------------------E==: r
AM J
1®
1
FM indoor antenna FM outdoor antenna
The supplied indoor antenna is for temporary use only. For
stable signal reception we recommend using an outdoor
antenna. Disconnect the indoor antenna when you connect
one outdoors. Lead the 75Q coaxial cable connected to the FM outdoor
antenna into the room and connect it to the FM 75fl terminal.
FM DE-EMPHASIS/CHANNEL SPACE switch
(Except for U.S./L, Canada and Australia)
The FM DE-EMPHASiS / CHANNEL SPACE switch on the rear panel is
set to the correct setting that prevails in the area to which the unit is
shipped. However, if the FM DE-EMPHASIS / CHANNEL SPACE setting
is not matched to the area where the unit is to be used; for instance,
when you move from area 1 to area 2 or vice versa, desired reception of
AM / FM broadcasts is not expected. In this case, change the FM DE­
EMPHASIS / CHANNEL SPACE setting in accordance with the area
corresponding to the table. Thè FM DE-EMPHASIS is switched over at
the same time.
•When changing the setting of the FM DE-EMPHASiS / CHANNEL
SPACE switch, first disconnect the power cord, then reset the channel
space switch, connect the power cord again, and turn the power on.
Area CHANNEL
SPACE freq.
FM J
DE-EMPHAsfl
1
U.S.A., Canada, and South
American countries
FM; 100 kHz
AM: 10 kHz
75 ps
2 Other countries
FM; 50 kHz
AM: 9 kHz
50 ps