Kenwood KR-V990D - Manual (Page 5)

i^tiniiih'tinnMifinHainh.'Mnaihnì:
O REMOTE POWER key
Use to switch the power ON/STANDBY
when the MAIN POWER is turned ON.
O Tone Control knobs
O ISIumeric keys
O STANDBY indicator
© AC-3 indicator
Lights when an AC-3 format signal is be­
ing played back.
© OVER LEVEL indicator -¡22
Lights when the level of the signal being
input is too high.
O DSP LOGIC key -¡22
Use to turn on, or switch, the DSP LOGIC
mode.
© AUTO/PRO LOGIC key
Use to turn on, or switch, the DOLBY
SURROUND mode.
© DOLBY 3 STEREO key -|22
Use to turn on the DOLBY 3 STEREO
mode.
© STEREO key -23
Use to cancel the surround mode.
© INPUT SELECTOR knob -|23
Use to select the input sources.
© VOLUME CONTROL knob -23
0 MAIN POWER key
Use to turn the POWER ON/OFF.
© PHONES jack -¡^
Use for headphone listening.
© DIRECT key -L^
Use to tune radio stations directly by nu­
merical input.
© MEMORY key -¡^
Use to store radio stations in the preset
memory.
© SPEAKERS A/B keys -¡^
Use to turn the speakers ON/OFF.
© TAPE atMONITOR) key -23
Use to monitor a recording.
© LINE STRAIGHT key -23
Use to listen with high quality sound.
m BALANCE keys -23
Use to adjust the volume balance between
left and right.
© VISUAL FIX key -23
Use to lock on to the current video input.
m AUTO key -22
Use to select the auto tuning mode.
© TUNING keys
Use to tune in radio broadcasts.
© BAND key -22
Use to select the broadcast band.
© LOUDNESS key -23
Use to emphasize deep base sounds.
© VIDEO-3 terminals
it
MOTE POWER switch STANDBY mode
'hen the receiver's power cord is plugged in to an AC outlet and the MAIN POWER key is turned ON, the STANDBY indicator will remain
lit, regardless of the ON/STANDBY setting of the REMOTE POWER switch. This Indicates that a small amount of current is being
supplied to the receiver in order to back up the memory contents. This is called the Standby mode. When the standby indicator is lit, the
receiver can be switched ON/STANDBY from the remote control.