Kenwood KR-V990D - Manual (Page 20)

Keys or controls used in this operation.
Surround set UP
To obtain the most possible enjoyment from the receiver's various surround modes, be sure to complete the surround set up
as shown below.
Speaker placement
Front speakers ;P!ace to the front left and right of the listening position. Front
speakers are required for all surround modes.
Center speaker: Place front and center. This speaker stabilizes the sound image
and helps recreate sound motion. Be sure to connect a center
speaker when using the Dolby 3 Stereo mode.
Rear speakers : Place to the direct left and right, or slightly behind, the listening
position at even heights, approximately 1 meter above the ears
of the listeners. These speakers recreate sound motion and
atmosphere. Required for surround playback.
Sub-woofer : Reproduces powerful deep bass sounds.
• Although the ideal surround system consists of all the speakers listed above, if you don't
have a center speaker or a sub-woofer, you can divide those signals between the availabl
speakers in the following steps to obtain the best possible surround reproduction from
speakers you have available.
Dn t
>bj^
3
Go to the SURROUND SET UP screen.
I Select the speakers and enter the speaker distance.
O Select the speakers you connected to the receiver.
When you select the icons for the speakers you connected, they turn grey,
L,R Front speakers (left and right): Are already selected.
C Center speaker : Switches each time the icon is presse«
SMALL ^ select when using a relatively small center speaker.
LARGE -► select when using a relatively large center speaker.
LS, RS Rear speakers (left and right) : LS and RS are selected at the same time,
SW Sub-woofer
continued on next page
1
Tie. I
ge I