Toshiba LF494 - Manual (Page 34)

TOSHIBA
6 F 8 A 0 7 7 4
■ Control Keys
Changing the operation mode, checking or changing parameters can be done with these keys.
To operate these keys, you have to open the converter housing cover. Observe the following
precautions when you open the housing cover:
rnnetions of each control key when pressed are shown in the table l>clow.
Control keys
SET
□
►
□
Basic functions of control keys
Oocs into the iteins sdeetion aeijucTice.
K, 00 n/s
1—\ Al'.EX. CUftR
lit). 0 Ï '------- /
.selection sequence
Ones into the dct^Mcel-ltcni specifying sequence for each selcctetl iicin in
measarement, setting or calihralion modes.
Al :£i, CJRR.
selection sequence
A1:EX. CURB,
0
measurement mode
Stores the sclcct
2
:<j Juta in the setting mode.
Bl:UfllT 1
r — N
B1 :UNIT 1
% %
status of chairging the data Status of finish changing
Changes itenrs (alphabet letter and number) in the items selection sequence,
and changes parameters (numbers andi'or units) in the detailed-item specifying
sequence in measurcnient« selling nr calibration nnodes.
C2:RA^G£ 1
02. 000 in/s
date;[J,2UUOm/s
C?:RANGE 1
03. OOO
ñ / %
darctoOOOm/s
Starts and stops the totali/er in the incasurement mode. (Note)
F lOCO ,----- \ F tool ID' C
100.0 % w
1
ÛR.
0
%
step the totali/cr start the totalizer
Changes digits (alphabet letter and number) in the items selection sequence,
and starts the detailed-item specifying sequence by indicating the left-most
digit with the cursor_______
D1: DAMPING
00 s s
D1 : DAHPINO
00. 5 S
setting mode siaitjs of finish changing
Moves the cursor frocn Ictl Iti right (from the right end reverts to the left end) in
Gl : COUNT RATE 1
—A
Cl: COUNT SATE
1. 23£-4
* —/ [. 23E-4 m’
Indicate cursor un^er ‘ I ’
Indicate cursor under
Resets the iotaligcr in the measurenient cnodc. (Nutgl
F '000 C 1
----\ F
0
m* c
0 0
.
0 1
£ 1 — / TOO 0
X
start the tiitaiizer reset the totalizer
Note: To operate the totalizer, it is preterabk U> set the indicating unit (UNIT I and/or UNIT 2)
to one of the units appropriate for totalization just to make sure it is operating eorreclly.
See 10.2, "Totalizer and Pulse Output/'
-
3 3
-