Terminal block cover, Terminal block, 200v class!power supply motor – Toshiba Tosvert VF-A5 User Manual
Page 30: Pb ^ po ^2 ^3, ^2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.5kW and larger units
Removal ot RO and SO terminal
shorting bars
Remove the two terminal screws as
shown below, and remove the
shorting bar.
Terminal block cover
^VftRNI^G]
• ttoMtan
t« Hift éfi to
tto to«rt№
RO, SO terminal block
for external wiring
ia.toetwnwL
Terminal block
Shorting bar
Shorting bar
Connected to the main circuit
terminals. Do not connect
external wiring to the lower
terminals.
4-M4 X 8L screws
With terminal cover
Recommended
tightening torque;
1.2N-m (lllbsH'n)
CON-mOL POWER SUPPLY
200V CLASS
Note) 400V systems are indicated as ’400V CLASS“.
Fig. 6.2.4 Control power terminal block (S.SkW to 30kW units)
Terminal block cover
r
PB ^ PO ^2 ^3,
^2 %
%
200V
class
!
POWER SUPPLY MOTOR
© ^
Note) 400V systems are indicated as 1400V CLASS
Terminal block
4-M5 X 10L screvtrs
With terminal cover
Charge lamp
(Lights when there is
a charge on the main
circuit capacitors)
Recommended tightening torque
2.4N-m (21lbs-in)
Ground
Connected to
inverter chassis
Fig. 6.2.5 Main circuit terminal block (S.SkW to 7.5kW units)
24