Toshiba Tosvert VF-A5 - Manual (Page 91)

U r
. U b
(Utility Parameters)
R P
I Industrial application parameters selection
This parameter is used to configure various industrial application parameters ( C r. D /~C r-.
LED display method
D E ).
PPL setting value Function
D Does nothing
/ Pump application
P Fan application
3 Conveyor application
H Hoist application
5 Textiles application
E Machine tools application
ID
T
PiwkMis setting Current setting
vsdue vshM
* The system is initialized after an
industrial application parameter
is selected.
Note)
If C ( ~ . D I to C i ~ . D E
are only unblinded via the blind
function, the industrial applica­
tion parameter values will not
be initialized (written).
* Refer to the industrial applica­
tion parameter tables starting
on page 125.
P Standard setting mode selection
All parameter values can be automatically changed to standard values at one time by selecting one of the
following settings:
LED display method
t y P setting value Function
D Does nothing
1 50Hz standard settings
E 60Hz standard settings
3 Return to factory settings
y Trip clear
5
Save user-set parameters
£
Type 5 reset
n
Initialize inverter typeform
ID
T
PrwrkHts sstting Currwtt Mttina
wsiu* vskw
fc !dP I n is used to clear an E t b J P error that may occur when the control PCB is installed in a
different inverter unit, and to reset the typeform to that of the new inverter. If an inverter typeform error occurs
when the control PCB has not been changed, do not execute a t iJP H . but contact your service
representative for repairs.
will save the current parameter settings. Even if parameters are changed, each parameter
This can be used for retaining
t b P 5
can be reset to previously-saved values by executing a
individualized user settings.
tyP £
- 85 -