Toshiba Tosvert VF-A5 - Manual (Page 65)

u r .
5 tz {Terminal Selection Parameters)
L F b r E H
H r E H L r E H
Low speed, acceleration/deceleration
complete, speed reach output
signals
L F Low-Speed signal output frequency
Speed reach detection band
H r E H
h r E H L r E H
o t o
~ 1 0 1 : 3 Output terminal selections
Speed reach HI frequency
Speed reach LO frequency
A signal is output when the output frequency exceeds the set low-speed detection frequency | F
This can be used as a magnetic brake open/close signal, etc.
Time [S]
* The speed reach signal is also output when a preset speed is reached.
* The low speed signal will turn OFF when DC injection braking (refer to C r - , P r
during a decelerated stop.
d b P ) is applied
Note) The speed reach signal is output when the frequency is greater than H r C H . and turned off
when it is less than ( C H j ■
-
59
-