Futaba GY701 User Manual
Page 35
T
AIL
R
OTOR
S
ERVO
I
NSTALLATION AND
S
ETUP
Following your transmitter instructions, pro-
gram your transmitter as follows:
Enable the gyro function within the transmit-
ter.
Set the gyro mode to AVCS (GY) within the
transmitter.
Set the remote gyro gain to 70% AVCS in the
transmitter for the Normal and Hold flight
conditions and use 40% AVCS for all idle up
conditions. See “Setting The Gain” section
later in this manual for more details.
Set the Tail Rotor ATV/EPA to 100% for both
left and right.
Set D/R to 75% for both left and right. This
will reduce the maximum pirouette rate.
Make adjustments to these values once the
initial test flight has been completed.
It is recommended that you run 30% soften-
ing expo on the tail rotor channel.
ｎWARNING
ｌ Do not connect the tail rotor servo to the gyro
until the servo type has been selected. Operating
the servo using the incorrect setting may damage
the GY701 or the servo.
Once these steps are completed, turn the receiver
power on and allow the gyro to initialize. Follow
the instructions within the “Gyro Basic Setting”
section of the manual and select the Servo Type
that matches the servo you have chosen to use.
Power down the receiver for now.
35