Futaba GY701 - Manual (Page 36)

T
AIL
R
OTOR
S
ERVO
I
NSTALLATION AND
S
ETUP
Install the tail rotor servo into the mechanics
and connect the servo to the gyro. Remove
the servo arm screw from the servo. Turn the
receiver power on and allow the gyro to ini-
tialize. Enter the “Gyro Basic Setting” mode
and go to parameter (4) “Servo Limit Point
Setting”. While in the servo limits parameter
the servo will remain centered.
90°
Place an appropriate servo arm onto the servo
and ensure that it is perpendicular to the tail
rotor pushrod as shown. Remove the unused
sides of the servo arm.
Install the control ball supplied with your he-
licopter onto the servo arm. For larger electric
models or nitro powered models we recom-
mend placing the ball 13.5mm from center.
Once the control ball has been installed place
the arm back onto the servo ensuring that it is
perpendicular to the tail rotor pushrod. Install
the servo arm screw.
13.5mm
36