GIN Genie Lite - Manual (Page 13)

13
Rescue Installation guide
Installing the speed system:
Pull the speed line down through the hole
on the side of your harness from above, and
thread it through the pulley as shown in the
illustration.
Pull the line through the exit ring at the
front of your seat.
Tie the end of the line to your speed bar
making sure that the line length is correct.
Connect the elastic cords from side loops of
speed bar to the side loops of your
footplate with correct tension.
If the tension is too high it will be difficult to put your feet into the cocoon.
Take care that the speed bar line lies free in your harness without any tangles.
To use a larger pulley, you can detach its own pulley and connect to the rear loop on the harness.