GTCO Roll-Up III - Users Guide User Manual
Page 10
Roll-Up III 10
The
menu button sets your preferred digitizer orientation. The
button toggles
the digitizer alarm off and on. The
button activates the Custom Configuration menu.
When using the SuperSet Menu, a tone will sound indicating a successful selection when
you click on the
or
buttons. Four tones will sound when you click on
or
.
(See the Roll-Up III Tones section for a complete table of the Roll-Up III tones.) The number
buttons
through
are active only after clicking on
for Select Mode.
NOTE: Units built before October 8, 2014, have serial Plug-N-Play enabled for SuperSet
Code
. On these units, use
instead of
. This SuperSet
Code has the same settings, but Plug-N-Play is disabled.
Changing the Digitizer’s Orientation
Roll-Up III lets you choose between two different digitizer orientations: you can orient the
digitizer with the controller Housing on your right (the factory default), or you can orient it
with the Housing on your left.
To change the orientation of the digitizer:
1. Turn the digitizer to the desired orientation.
2. Relocate the origin by clicking on the
button on the SuperSet Menu that is
located in the lower left corner of the digitizer. You will hear four short tones when
you do this.
NOTE: The orientation of the 20 x 24 Roll-Up III cannot be changed.
Turning the Alarm Off and On
You can disable the alarm if you do not want to hear a tone each time the transducer
button is pressed. When the alarm is off, you will still hear diagnostic and menu-related
tones.
To turn the alarm off or on:
Click on the
button – which toggles the tones on or off – on the SuperSet Menu.