GTCO Roll-Up III - Users Guide - Manual (Page 9)

Roll-Up III 9
Using the SuperSet Menu
The SuperSet Menu is the row of buttons printed in the lower left and upper right corners
of the digitizer.
The SuperSet Menu makes it possible to configure the Roll-Up III so that it sends the
appropriate information for a serial connection to the software being used on your
computer (see Table 1 section of this manual for an extensive list of digitizer software
applications and their codes). It is used to prepare the digitizer to receive specific, detailed
custom configuration information from the Custom Configuration Menu for some serial
installations. In addition, the SuperSet Menu can be used for both serial and USB
connection configurations, to set and change the digitizer orientation, and to turn the
digitizer alarm off and on. Use your stylus or cursor to click on the menu buttons to make
your selections.
The menu button initiates Select Mode. Two-digit numeric codes are entered after
Select Mode is activated. Most software supports Wintab using the TabletWorks drivers,
whose SuperSet Code is
on the SuperSet Menu. The Roll-Up III comes from
the factory with the SuperSet Code pre-configured.
NOTE: Select Mode will not work with the USB interface. USB talks to Wintab drivers
exclusively.