GTCO Roll-Up III - Users Guide - Manual (Page 7)

Roll-Up III 7
1. Select a large, flat, nonmetal
surface on which to place the
Roll-Up III. Clear all items from
the surface.
2. Remove the Roll-Up III from its
cardboard tube container and
unroll it on the selected
surface.
3. Connect the transducer –
cursor or stylus – to the
appropriate jack on the
digitizer’s Connector Panel. The
connector is keyed and will fit
only the correct jack. Do not
force it.
NOTE: Do not attempt to remove the controller from the housing. Doing so could damage
the digitizer and void your warranty.
USB Connection
The Roll-Up USB port connection is USB 1.1 and 2.0 compatible. When the digitizer is
connected to the USB port, Windows will recognize that there is a new device connected. If
Windows displays the Found New Hardware prompt, follow the onscreen instructions to
complete the driver installation.
1. Connect the interface cable to the USB jack on the Roll-Up III Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it.
2. Attach the other end of the USB cable to any one of the USB ports on your
computer or USB hub. The digitizer will beep four short tones, indicating it is
powered on. View the Roll-Up III Tones for a complete table of the Roll-Up III tones.
3. SuperSet Codes are not applicable when using the USB connection.
NOTE: Power is supplied through the USB port. No additional power source is needed for
this installation.