GTCO Roll-Up III - Users Guide - Manual (Page 8)

Roll-Up III 8
RS-232 Serial Connection
If your software application is not Wintab-compliant, be sure to set the correct two-digit
Application SuperSet Code before connecting the serial cable to the computer. SuperSet
Codes can be found in Table 1. If your application is not listed in Table 1, find the
configuration settings that apply to your application in Table 2 and use the corresponding
SuperSet Code. If an appropriate SuperSet Code is not listed in Table 2, use the Custom
Configuration Menu stored in the slot on the end of the Roll-Up III housing to configure
your Roll-Up III.
1. Plug the power supply into an AC outlet. Connect the power supply to the
appropriate jack on the Connector Panel. The digitizer will beep four short tones
(see the Roll-Up III Tones section for a complete table of Roll-Up III tones), indicating
it is powered on.
2. Connect the RS-232 serial cable to the serial jack on the Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it.
3. Configure the SuperSet Code. The Roll-Up III comes from the factory with the
SuperSet Code pre-configured. (See Using the SuperSet Menu.)