GTCO AccuTab VI - Users Guide - Manual (Page 12)

AccuTab VI 12
Optional RS-232 Serial Connection
1. Connect the RS-232 serial cable to the serial jack on the Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it. Join the other
end of an RS-232 serial port on your computer.
2. Plug the power supply into an AC outlet. Connect the power supply to the
appropriate jack on the AccuTab VI Connector Panel. Turn the power switch on.
The digitizer will beep four short tones (see AccuTab VI Tones section of this manual
for a complete table of AccuTab VI tones), indicating it has power.
Tablet Power On
The AccuTab VI power switch is located at the rear of the tablet on the Controller
Connector Panel. When turned on, AccuTab VI’s Indicator Light will begin blinking and the