GTCO AccuTab VI - Users Guide - Manual (Page 25)

AccuTab VI 25
i. You can click on the AccuSet Menu buttons on the tablet using the
tablet’s cursor to activate these configurations: plus
through .
8. When you have finished, select Exit or Close from the File menu.
a. Exit will close the Tablet Configuration Utilities.
b. Close will exit the Advanced Configuration Screen and return to the Tablet
Configuration Utilities window.
Learning the Basics
You will find that the AccuTab VI tablet is as easy or easier, than using a mouse. The
AccuTab VI cursor is more accurate than a mouse, giving you greater control over your
movements.
Using the Cursor
The cursor does not need to be in contact with the tablet surface in order for the digitizer
to sense its presence. It can be detected up to 1/2" above the Active Area. When the
cursor is in the zone above the surface of the digitizer, it is referred to as being in prox. The
Indicator Light will go from a blinking green light to a solid green light when the cursor is in
prox of, or touching, the digitizer’s surface. The in prox zone allows you to trace through
materials placed on the digitizer’s surface, such as a drawing or a book.
When you use the cursor, the intersection point of the crosshairs on the lens identifies the
point you are selecting. The crosshairs are etched on the bottom of the lens to increase
accuracy. For maximum precision, look through the lens from a position directly over it.
Button 0 on the cursor is used as the pick, or left mouse, button. All other buttons are
defined by the TabletWorks software or through your own software application.
To illuminate the lens area of the high-accuracy cursor, press and hold any button in the far
right column (3, 7, B or F) at the same time, press and hold any button in the far left column
(0, 4, 8 or C). The right column button must be held down while pressing the left column