GTCO Summagrid IV - Users Guide Part 2 - Manual (Page 12)

Summagrid IV 12
1.13.3 Command Syntax
Activate the annunciator for
approximately one quarter of a second;
emits last tone chosen.
Selects one of four different tones for
the annunciator and sounds that tone.
<ESC>A
<ESC>Y(n)
n=1 low tone
n=2 medium tone
n=3 high tone
n=4 highest tone
NOTE: If you want to hear a tone every time a switch is selected, be certain that DIP switch
C5 is in the ON position and use the following command:
Enable Audible Feedback <ESC>MT1
Disable Audible Feedback <ESC>MT0
1.14 Relocate Origin Command
1.14.1 Description
This command allows the user to relocate the tablet origin (0,0). The default origin
location is the lower left-hand corner of the tablet active area. The user may move
the origin to either one of four pre-defined locations or to a user-defined position
anywhere within the tablet active area. The pre-defined locations are listed as
follows:
 Center of Tablet
 Lower Right Corner
 Lower Left Corner
 Upper Left Corner
 Upper Right Corner