GTCO Summagrid IV - Users Guide Part 2 - Manual (Page 9)

Summagrid IV 9
Both Stream and Switch Stream modes may also be used in combination with
Increment Mode, an increment filter that prevents duplicate coordinates from being
transmitted to the host.
1.8.2 When to Use
Stream Mode: Best for applications where speed is important, such as paint
programs and handwriting applications.
Switch Stream Mode: This mode is best for handwriting applications.
1.8.3 Command Syntax
Stream Mode
Switch Stream Mode <ESC>M0
<ESC>M2
1.9 Report Modes: Set Report Rate
1.9.1 Description
The Set Report Rate Command is used to adjust the rate at which reports are sent to
the host when the tablet is in Stream or Switch Stream Mode.
1.9.2 When to Use
Use this command when applications require report rates other than the maximum
Summagrid IV report rates.
1.9.3 Command Syntax
Set Report Rate <ESC>Rn
n=0
n=1
n=2
n=3
n=4
n=5
n=6, 7, 8
n=9
1reports per second (rps)
2 rps
5 rps
10 rps
30 rps
60 rps
85 rps
MAX (up to 150 rps at
19200 baud)