GTCO Summagrid IV - Users Guide Part 2 - Manual (Page 3)

Summagrid IV 3
1.2.2 Command Syntax
Change Emulation
Microgrid UIOF
MM/SummaSketch
CalComp
GTCO <ESC>z(n)
n=0
n=1
n=2
n=3
1.3 Communication Protocol Commands
1.3.1 Description
These commands are used to change the Summagrid IV communication protocols
from the host.
1.3.2 When to Use
The user needs to change the communication protocols when working with multiple
applications that require different information, such as baud rate, parity and
number of data bits.
1.3.3 Baud Rate
Baud rate refers to the number of bits transmitted each second between the host
and Summagrid IV, or between the Summagrid IV and the host. The available
Summagrid IV baud rates, along with their corresponding ASCII commands and DIP
switch settings, are listed in the table below.