HONDA 2003 Accord Coupe - Owner's Manual - Manual (Page 179)

When that disc ends, the next disc in
the CD changer is loaded and played.
After the last disc finishes, the
system returns to disc 1.
To select a different disc, press the
appropriate side of a preset bar (1
6). If you select an empty position in
the CD changer, the system will go
into the loading sequence (see page
).
Each time you press and
release it, the system skips forward
to the beginning of the next track.
Press and release
to skip
backward to the beginning of the
current track. Press and release it
again to skip to the beginning of the
previous track.
You can use the SKIP bar while a
disc is playing to select passages and
change tracks.
To move rapidly within a track, press
and hold the left or right side of the
SKIP bar. You will hear a beep and
the system will continue to move.
Press
to move forward, or
to move backward. Release the
bar when the system reaches the
point you want.
Select the CD changer by pressing
the CD button. You will see ‘‘CD’’ in
the display. The system will begin
playing the last selected disc in the
CD changer. You will see the disc
and track numbers displayed.
This feature, when
activated, samples all the tracks on
the selected disc in the order they
are recorded on the CD. To activate
the Scan feature, select the Scan
mode by pressing the SCAN button.
You will see SCAN in the display.
The system will then play the first
track for approximately ten seconds.
If you do nothing, the system will
then play the following tracks for ten
seconds each. When it plays a track
that you want to continue listening to,
press the SCAN button again.
174
Operation
Audio System
Comf ort and Convenience Features
SCAN
176
Main Menu Table of Content